Smart-technologies 3000i Bedienungsanleitung PDF herunterladen (Seite 38)

3000i Installation Guide

Startup Scenarios

If your 3000i is situated in a multi-user meeting room, you may find the unit in a non-operational

state when you enter the room. The table below describes what you may need to do to restore

the 3000i to a fully operational state.

What You See What You Should Do

•

Screen is black

•

Standby LED is off

The projector is in standby mode (with lamp off).

Press the Projector Standby button on the Control

Panel. The LED indicator will start flashing, and,

after 30 seconds, either a blue SMART "No Source

Signal" screen appears or the screen will be

restored to its pre-standby state.

If the SMART "No Source Signal" screen appears:

Touch the screen, press the Display Source button

or press a key on the wireless keyboard. If the

previous user logged off, the logon screen appears.

Otherwise, the screen is restored to its pre-standby

state.

Log on as usual (using the wireless keyboard).

•

SMART "No Source Signal" screen

•

Standby LED is steadily illuminated

The projector lamp is powered up, but the computer is

either off or in standby mode.

Press a key on the wireless keyboard to wake up the

computer. The login screen appears.

If the SMART "No Source Signal" screen remains:

Open the front doors and turn the computer on (or

press the computer reset button). The logon screen

appears.

Log on as usual (using the wireless keyboard).

•

Screen is black

•

LED indicator is blinking moderately

quickly

Di l S LED i ill i d

The projector lamp is in the process of powering up. The

logon screen appears in 30 seconds.

•

Screen is black

•

LED is blinking very quickly

•

Display Source LED is illuminated

The projector lamp is in reversible standby mode. Press

the Projector Standby button to instantly restore the

image. Or allow standby to continue for five minutes until

the LED indicator begins to blink slowly. After 30

seconds, the projector lamp will go into full standby

mode. At this point, follow the first set of instructions in

this table.

•

Logon Screen

The projector lamp is still on, so you can log on as usual

(using the wireless keyboard).

•

Projector Standby button has been

pressed

•

LED indicator remains off

Problems with the projector itself are interfering with the

normal projector lamp warm-up. Examine the projector

status LED indicator, and then consult the

troubleshooting section of the

NEC MT1065/MT1060

User's Manual

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Smart-technologies 3000i Bedienungsanleitung Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Smart-technologies 3000i